Recent content by magico

Agree about the bevel on the outside...I had a couple like that in my old house. Fortunately they were on the upper floor. Glue them in if need to keep them. Gorilla glue

Can you not add charcoal filters to your extractor hood

That's exactly what I'm doing pal... shot blasting? Really that's a step too far.

If it was mine I would of had the grey done anyway but it's not. Probably would of been OK if she hadn't used grit salt on it in the winter also. I'm in contact with a company who sell sealant online so I'll see what they recommend. Personally can't see a problem with just cleaning the best I...

Cheers anyway mate

Thanks.....Could you point me to a specific product or brand....seen a sealant with a tint but not sure if that would be sufficient

Hi the mother in law needs a bit of advice. She had her front garden area concrete imprinted a few years ago in a beige colour, had it repainted grey a couple of years ago but it wearing off again...what product would do to recolour and seal please Thanks

Ok I'll double check that socket too...thanks. To be fair it's lasted atleast a couple of years

Yes John both next to each other. Basically just fed both plugs up into the double socket above worktop for now. But at the weekend will take a spur from said socket down and to a cupboard and install a double socket for both to plug into then. Thankyou mate. Think I was just over thinking...

So just take a spur from double socket into a single socket in a cupboard next to drier and plug into that? ......the next problem is I have a small chest freezer. That was also in same extension lead. Would I do same from the next socket on circuit...take a spur and into single socket again...

Is it good practice to take a 13amp fused spur from a double socket in circuit in my kitchen to hard wire my tumble drier? Some absolute nob head had it plugged into a extension lead under kickboard into a single socket. Thinking of getting rid of the single socket and using Junction box. Then...

Meant to say it's fitted vertically

Hi all. I'm having the top section of the front of the house rendered and under the canopy and between windows cladding in with composite slatted cladding board. It's a brick house and going to use timber battens 38mm and screw the board to the the battens. Would it need a vapour barrier or...

Thanks for the advice. I've now decided to get a firm in to do it. If it was just a single story window I'd give a go but nah too much for me.

Hi im thinking of changing the 2 upvc windows on a L shaped bay. Lower floor and upper. I've installed smaller windows before, these being by the far the biggest for me. 3m width x 1.5m high and a 500mm side panel as a L shape. I understand I need a corner post to connect the large window to...