I haven’t unfortunately no. Seem to have every size but. Was gonna use the blow torch but I’ve no gas left. Tend to use crimp fittings with work these days.
Your not wrong. What a pain! I’ve got 17mm and 19mm ♂️ Been messing with it this morning but I need an 18mm ring spanner like you say. I’ll have to pick one up because otherwise it ain’t budging.
its 100% the flow turbine. Don’t get any lights when hot tap opens. Put a magnet to hall effect sensor and hot water kicks in. Just can’t get the thing out!!
I haven’t even checked this mate. I don’t really work on boilers so haven’t got the best knowledge. If it flashes there’s an issue and if it’s solid it’s fine, right? I’ve managed to dig out the fault finding manual. If it’s flashing I’m best to check the filter in the mains assembly and then...
Hi guys.
just after a bit of advice. I am a plumber just not massively knowledgable when it comes to boilers. I’ve got CH but haven’t got any hot water. Initial thought was diverter valve. I have replaced it along with the Motorhead and still haven’t got any hot water. CH still works fine but...