Recent content by mark1111

i am no expert on this, but i would start at the highest point and butt up to the corner over the stairs (hope this makes sense) then you have a point to work away from both upstairs and down stairs. as for overlapping the corners, i dont advise it. i cut my lining paper up to the corner rather...

hi ya, i am due to paint a kitchen ceiling this weekend. it is a wooden panelled ceiling,not sure if its stained or varnished yet. what do i need to do regarding prep work and priming. i plan to emulsion the ceiling. also i would like to have it done this weekend as i am not local to the...

i have a kitchen ceiling to paint this weekend, its wood that is either stained or varnished, can anyone advise on prep work/ primer i may need before i emulsion. thanks

Its a 3port mid position valve, a hortsmann c27 programmer, honywell cyl stat and room stat. i changed programmer because i was getting a live feed on water off feed when water was on, thinking this was effecting the valve. i now dont get this feed on(grey wire ) when water is on. i have...

Yes. if i run heating boiler fires up fine, i can then turn on hot water and run the 2 together. when room stat switches off the boiler cuts out. if i just ask for hot water only, the boiler fires up for about 10 seconds and then cuts out showing fault code.

the cylinder will heat if i call for heating and hot water, (i put heating on to fire up boiler and then switch on hot water) once room stat switches off, the boiler stops and then flashes fault code. if i ask for just hot water the boiler fires up about 10 seconds and then shows fault code...

can someone advise me on a hot water problem please ? i have suddenly lost hot water. if i run heating i can then get hot water. i have replaced cylinder stat, 3 way valve and programmer so i presume that it is not an electrical problem. i am starting to think that it may be a partialy blocked...

can someone advise me on a hot water problem please ? i have suddenly lost hot water. if i run heating i can then get hot water. i have replaced cylinder stat, 3 way valve and programmer so i presume that it is not an electrical problem. i am starting to think that it may be a partialy...