Recent content by mbev51

Hi, ive read through your discussions on the topic with intetest. There is no harm in my electrician putting it on its on circuit and so we may well do that. I will talk to him about it. As for the plumbing in, i have to use a plumber with g3 certificate. I have installed one of these in in...

Hi, my electrician finally turned up to view the work in my outbuildings. He says the 80l unvented presurized water heater ive just bought will have to go on its own circuit because its more than 15l. The info from the page of the ebay seller says a 13amp fused spur. Its a 2000w heater...

I give up. No more replues are necessary. Thank you.

No ducting going in cable will be clipped to wood for much of its route. Would it be possible to have comments on my question.

Im asking my electrician when he comes. Im also asking this forum. I need to lay the cable asap as im going to be incapacitated for 4 months in a weeks time.

Hi, will be acquiring an electric kiln single phase to install in outbuildings shortly. The outbuildings have a new consumer unit. The cable run will be about less than 15m. The cable will be nowhere near insulation. Can you confirm that a 6mm grey cable will be fine. I intend to run the...

hi just to clarify, its dropping from the bottom of the pump not at a joint, just the lowest point.

hi Hello to all on the forum. We have the above non condensing boiler, 5 years old and its leaking. Its from the lower water joint going into the pump, you can see it clearly from underneath. The pipe is plastic and looks to have a metal clip securing it. Has anyone dealt with this before...