Recent content by meracl

Thank you for your help. I'll try to contact a local company and watch it closely for power cuts.

Thank you for answering secureiam. At least once of all that times i got the fault im sure there wasn't any power cut. I always had to manual reset it after any power cut since i installed it. Wintex: Area timers & options, options tab No. 37 AC Fail engineer reset is blank (im not sure...

Hello all, I have installed that panel 2 years ago and i have the following issues. Panel allerts: MAINS POWER OFF PS FAILURE POWER O/P FAULT system 12v Going through the log in wintex i have hundreds of logs for the last 3-4 days: MAINS AC ALARM Panel and version number is...

Changed it. Global config oprions 31 Lets see how it goes. Thanks

Thanks for your reply. ELITE 48 ENG SW V2.02 LS1 I'll search on how to change that.

Hello, Since installed the panel almost a year ago the clock wasn't so accurate so i had to set the time every couple of weeks or so. But the last few days is one minute ahead every 1 hour. Any ideas on what is wrong? Thank you for you time

Im new here so was unfamiliar with the thank you button!!!! Again thanks for helping me and mentioning the thanks button!!! 8)

Thank you very much HOOVER!!!!! I used master code twice and that DID worked. System was reset!!! Thank you very much again!!

Thanks for replying!!! ELITE 48 ENG SW V2.02 LS1

Hello all. I installed that panel 6 months ago and had no problems until today. I came back from work and seems there was a power cut. I have system alerts displayed which i can't reset them. MAINS POWER OFF PS FAILURE POWER O/P FAULT system 12v I have the master, engineer and user...

Thanks a lot for replying RF lighting

Thanks for the reply Sparkymarka. With the battery jumper to the on position will the bell activate if i power off the panel? (remove mains and battery from panel) If yes how is that dissabled if you wanna power off the panel to add something?

Hello i have installed a texecom premier 48 panel with premier com GSM unit a premier elite odyssey 3 bell and a pyronix twin alert. I managed to program the prenter header through wintex and is shown on the send sms but how to you program the name (first line of sended SMS). Manual says name...

Thanks a lot i think i found it. I have so much to learn about alarms is my first alarm system!!

Hello all, Can anyone please help me with a problem i have programming the alarm system? My problem is i have 2 keypads one next to entry/exit door and one in the bedroom. 2 areas are programmed area A entry/exit which includes the entry exit door and sitting dining kitchen pirs Area B...