Recent content by MICH43L

No pics yet (floor not set), but the boss was very good about it and agreed it needed redoing. They came off easy enough - maybe not fully set - and by end of day they had redone them. Bit stressful, as they were end of line and in the worst case we'd have had a full-on dispute, not enough...

He's redoing it now. Thanks for confirming.

I'm the customer.

New plasterboard, it was battened out level.

A few pics of the current state of play. Not my handiwork. Difficult to get good pics, but some 4-5mm differences in tile height. Thoughts?

Thanks all, will look at the alternatives.

Hi all, I have a Yellow Irwin pipe bender which does 15mm & 22mm. Does anyone know if the Irwin 12mm guide T560865 will work with this? Thanks M

I decided to put a new carpet and a lick of paint in the loft room. A couple of hours' work. Two days later... The problem was the old ceiling was sagging, and only insulated at the top. Truth is, I was concerned that there may have been no air gap at all, and mold was starting to grow on...

Hi, I have to seal my block paving, and all the info says I need a Viton sprayer otherwise the rubber seals will perish. It's a job I'm going to do once, and I happen to have a spare old non-viton sprayer hanging around. The job will probably take me 2 hours max. Hate to be a part of the...

I guess the only question is how they affect gas pressure.

Yes, the boiler guy mentioned magnetic, but i can only find y strainers and Sulphidation Filters.

Hi all. We have a new combi boiler brought down by shale/contaminants in the gas supply. All fixed under warranty, but not sure whether the issue will have been fully resolved by a recent internal pipework upgrade from 22mm to 28mm, or if the cause will be upstream in the meter or supply...

Cheers. Every day is a schoolday :-)

The bucket was just a temporary measure to figure out where the water was going (and how much). Not sure what volumes of water to expect from the condensate pipe over the course of a week - any thoughts? Would a damaged heat exchanger not be picked up on a service? Are they expensive to...

Thanks all, very helpful. I will check the other pipe. Heating has not been on yet.