Thanks everyone. Very helpful, even if it’s bot the answer I was looking for. Saved a lot of faffing about trying to work out why it wasn’t working. Drayton onto eBay and I’ll give the Hive a go.
Thanks sxturbo and CBW. There isn’t a thermostat anywhere so I assume it was set up to run the CH for as long as the timer was on. As for Y vs S plan, I’m not sure I’m afraid. The only valve I can see is this one below the HW tank. Not sure if you can tell from that.
Hi,
I have recently installed a Drayton Wiser Kit 2 to replace an old Potterton EP2001 with an oil fired boiler (Grant Euroflame). I’ve wired the Wider with the same wiring setup as the Potterton, expect without the link wire from L to 5 (as someone helped me with on this forum). The HW is...
Hi, not sure if this is the right place to ask this question, but I have a simple set-up with a Potterton EP2001 with the attached wiring diragram that I’d like to switch to a Wiser set-up. 3 is hot water and 4 is CH. Do I just copy the wiring in the EP2001 but without the link wire between L...