Recent content by MK01

Hi - I was wondering if anyone would have a clue about the issue I have been facing with my wiser hub 3 channel (WT734R1S0902) I have two heating zones controlled by two danfoss hpa2 valves (combi boiler hot water on demand) So I only use channel 1 (zone1) and channel3 (zone2). Since purchase...

I know this is is an old post but I have the same issue.. and its intermittent! Upstairs (zone2) gets warm or hot when zone 1 is on but only sometimes :( The danfoss hap2 vavles all seem fine and thinking reverse circulation ? I am going to try and unplug zone 2 valve and if the zone2 rads still...

Thanks mate, but shape what, the bracket ? If yes donyou mean make the end that goes under the seal shorter so it doea not reach that 2nd lip ? if yes then i dont think those brackets will hold like that (i had the same idea and placed a bracket up to rhe 2nd lip and it was wobbly

Hi, I started a mini project to keep the Mrs happy (happy wife happy life.. they say :-D) She wanted perfect fit blinds on the back kitchen patio doors and window... I purchased, measurements all good (used Gatortape) BUT The brackets that are meant to slide under the rubber gasket on the...

Also if the 3rd option is "allowed" then whats the best practice to extend the current cable coming out the wall so that it can stand up to the outside elements ?Thank you in advance for your time on this

Hi, I hope everyone is doing well! I have maybe a silly question but want to make sure I dont cause any issues further down the road. My outside Lantern Light next to my front door has failed (the PiR unit has died) this fitting was supplied by the builder 3 years ago (new build). SO out of...

I done this in the end, tiny bit of glue and it’s sorted

New build home 3 years in….

Thanks mate, yh it’s the bottom one and thinking I can glue the crack in that flimsy bit, all that effort and it’s gonna happen again and again, plastic in winter is just too brittle and now days everything is built to fail rather than last..,it’s not causing any problems with cold or anything...

@ronniecabers thank you for your time and advice greatly appreciated

The rest of the mullion cap is fine it’s that little flapp bit on the the outside that snaps and cracks (this is the 2nd one in year - the first one was done under warranty but missed how it got replaced just come home to loads of plastics shavings over the floor :D

Thank you buddy, can I be a pain and ask for any tips on techniques to use or not to use to remove and I purchased dedicated glue for this as well to reinstall - but now thinking these little flaps on the outside or so flimsy they will go brittle and snap at the slightest touch in future… is it...

Hi, I am new to the forum and was wondering if anyone can provide advice on how I would remove a mullion end caps (eurocell chamfered 70mm) from my existing upvc French doors ? They seem to be glued on with no mechanical fixings and need to replace one as the outside lip has cracked. Is the only...

Hi, I am new to the forum and was wondering if anyone can provide advice on how I would remove one of these mullion end caps (eurocell chamfered 70mm) from my existing French doors ? They seem to be glued on with no mechanical fixings and need to replace one as the outside lip has cracked. Is...