Recent content by Monkeyboy73

  1. M

    24i and lukewarm radiators

    I have got round to removing the filter and found that it was clean. I have also spent ages balancing the system but still find the rads downstairs are still cold. Any other suggestions? I have noticed that the burner light comes on for about 30 seconds and then turns off for a couple...
  2. M

    hot water a milky colour

    I had this with my 24i Junior. The following is from memory only, but I read that this is a side effect of condensing boilers. When the water comes out of the tap, the milky colour isn't sediment, but thousands of tiny air bubbles, a result of the oxygen in the water escaping. I was...
  3. M

    CH Timed vs Constant

    Thanks John Yes the hallway (which is where the Room stat is located) is very cold as are the walls. Is the different problem you refer to heat escaping? The boiler doesn't run on constantly, but it does switch on and off a lot. I have TRV's on all but the hallway rad and a towell...
  4. M

    CH Timed vs Constant

    I'd like to get a few expert opinions as to the best way to run a central heating system, mainly concerning condensing boilers. I had my Worcester 24i junior on timed and the boiler stat set to max in order to heat the rooms accordingly, I have a room stat set to 20 degrees and noticed the...
  5. M

    24i and lukewarm radiators

    Ok. Thanks for the replies.
  6. M

    24i and lukewarm radiators

    There is a filter on the return pipe to the boiler. Do I have to turn the water off and drain the system to remove it, or is there a simpler way?
  7. M

    24i and lukewarm radiators

    I have a 24i junior boiler feeding 1 towel radiator, 3 upstairs radiators and 4 downstairs radiators. Problem is the rads are only lukewarm, mainly downstairs. The flow pipe from the boiler is extremely hot as is the flow pipe to each radiator, but the return is only lukewarm. Would I...
Back
Top