I am going to add some insulated plasterboard to a room which is not insulated. This will involve stripping back the plaster to the brick, treating it then building it up again due to damp. There is a window but I'm not sure how to tackle the difference in depth when the new insulated...
Hi,
I'm trying to convert my current heating system to use the wiser thermostat and controller kit 1.
Here is my current controller
I have the indstry standard backplate underneath which is what I intend on replacing the above with.
Here is the diagram
The diagram is confusing me...
I'm planning on putting in a kitchen island that sits on a tiled rectangle. My plan was to install the island cabinets, tile around these then install the end panels and plinths. I don't have enough tiles to tile the whole rectangle. Does that sound like it will work ok?
Thanks
I'm planning on laying an engineered wood herringbone floor in my kitchen. The cabinets are not being removed but the doors, plinths, end panels, etc are being replaced.
My plan is to remove the plinths and end panels and lay the flooring up to the feet of the cabinets and then install the new...
Thanks for the informative answer. I am aware that my measuring is only a guide and until the worktop is going down those measurements are only good as a rough guide. If I had gone ahead and bought exact measured worktops it wouldve been 100% my fault when they inevitably dont fit.
Thanks again
Thanks JobAndKnock. The worktop i'm planning on buying comes in any size you want, not the standard 3/4m lengths. I provided the pictures with the measurements and they came back with a quote with the extra 10mm. I havent got a joiner yet hence why I am asking. I thought 10mm was not enough...
I am going to order a new worktop but I'm unsure how much excess is required to do a masons mitre joint.
I'm getting the worktop cut to size but I dont think they'll supply it with the masons mitre joint already cut. So I need to get the joiner to do that bit for me on site.
My current...