Recent content by MrNoob

Thanks Andy - that did the trick! Should I be concerned about the lack of earth wire? None of the switches have these and I've just had it all rewired!

Thanks Andy - I've added some pics. Things are a little more clear for me now. The middle switch has two cables in L1 as I have two seperate wall lights (duh!) To clarify, the wire that is currently in the com port on the right should be going into the left?

Hello, I replaced my white switches with some nicer BG ones, but in doing so I seemed to have messed up the three gang two way switch which was working as a one way switch. The switch controlled two seperate ceiling lights and one pair of wall lights. The situation I have now is the switch...

I've added a couple more pics to show the size of the room. The bigger room has the most visible dip, but both room are effected by what happened. The effected are in the big room is pretty much 2mx2m - from the wall to the middle of the pain splodge. As I will be laying down 6mm plywood...

The wall that I had knocked down by a builder and which is currently being signed off by buuilding control was sat in between the kitchen and dining room. The previous owner had already knocked through a wall between the lounge and the backroom. The floors in the picture are of the bedroom...

I've read the "how to level a very uneven floor" sticky, but wanted to double check before I order the material: 1) The floor in the upstairs bedroom has a very big dip of arround 25-30mm in over a 1.5m run before going back up again. The area that is suffering the dip covers two-thirds of...