Recent content by mrsgrnwd

Thanks Jules- It's unfortunate that they've kept the diagnostic so vague... I really dread having to call in one of their engineers, as it's out of warranty. Thanks again for your helpful reply, I hope maybe someone else can also shed some much needed light on this... Cheers, Mrs Greenwood

Hi everyone, Our Miele Novotronic W833 (5kg) washing machine has been acting up lately... The cycle runs fine, but when it's turned on (whether washing or not), the "Rinses/Rinse Hold" light on control panel keeps blinking constantly and quite quickly as well. It keeps blinking even while...

Sorry don't mind me! The door wasn't shut properly :oops: All working as it should now :D

Hey guys, Hasn't been a good year on the white goods front ... Thanks to zipper's help we managed to get our Miele condenser dryer working again (yay!). But I'm afraid our other buddy, a Miele Novotronic W833 washing machine, is wanting some TLC as well :( The washing machine was working...

Hey zipper! Thought you might like an update - NTC arrived and installed. Only just had time to do a load of laundry - viola! - all working as it should :D I'm over the moon - very, very happy!! Certainly would not have done it without your help and guidance. Thank you so much. Xx

Thanks zipper, yes, that's the wire I was thinking. ok, we'll try it with a new NTC (without new wire) first and see how that goes. Will keep in mind all the info you so kindly provided about the wire if that proves necessary... Off to order a new part :) Will keep you posted for sure!!

Thanks very much for your help and advice zipper. ok, we'll give it a go! Will report back how it goes... Do you think it's worth replacing the wire as well? Could you please let me know what kind of wire that is?

Thanks zipper, do you know the exact spares/part article number by any chance? How much do you reckon it'd cost?

Thanks zipper, my bad, that was me not paying enough attention, sorry :oops: ok, just did it as per instructions: same results as very first time "drying" flashes twice, 2 sec pause (repeats) "cool air" flashes once, 2 sec pause (repeats) Video is here: http://youtu.be/r61L2I2SNuk

Argh! Not so lucky, I'm afraid. We put a full load on automatic, all was running ok initially until about 18 minutes into it, the dryer started beeping and turned itself onto "cool air" mode. I put it in service mode and the lights were different this time - only the "drying" LEDs were...

Let's hope with a bit of luck we can escape the damage ($) - will report back tomorrow. Thanks so much zipper :D

Thanks zipper, miraculously it completed a 30 minute timed warm run without any problem this time, when before it would switch off to "cool air"! Not sure if plugging things in and out have helped or not :!: The numbers on the door are: Nr.: 40/89739582 M-Nr. 06985030 Out of...

Thanks zipper, just shows how little I know about dryers ... ok, I hope we got it correct this time around. We found the rear NTC plug behind the cable harness as you've instructed :D The one with the 2 thin grey wires, as circled in the first pic below. The resistance measured was...