Recent content by nairb999

Thanks Vulcan. Along with Johntheo definitely the way to go

Yep. This has been actioned

Thanks for clarification John so the other side I just leave open. I am an electrical engineer haha

Sorry John but Looked for a valve that could be suitable. So original feed pipe goes into one side. What do I do with the other side?

Plastic bag in place and will run for a few days. Just one question now if I end up with combined vent and feed solution I will install a valve as suggested. Do I leave the other side open or make a blank

Thanks John. Will give the plastic bag a go first. This my feed and vent just before going into the loft. So I can disconnect 15 mm elbow and t into 22 mm vent? Then cap disconnected feed pipe here and connect lever isolating valve/gate valve. ps never got round to filling ceiling gaps properly

Thankyou for detailed response John. The original cold feed was directly above the pump on the horizontal flow pipe. I was advised on this site to move vent and feed closer together. This morning with the help of my wife I have performed a number of tests. With the pump circulating I held my...

John your continual support is most appreciated. Just one extra piece of information I have not replaced a radiator. A little more detail on previous boiler did have air ingress on that system and that's why the H was modified and that did not have any effect so my hesitancy on changing to...

So you have used this configuration to solve air ingress issues on typical H configuration

Any thoughts on a temporary fix to prove that going to combined feed and vent would work?

Great advice. Along the same lines as others.

John as my cold feed is 15mm would it work to t that short piece of pipe to the vent pipe

Cold feed is 15mm

Lot to think about going forward and stopping air in the system. Thankyou to all who have assisted