Recent content by nay376

Thanks GalaxyGuy your advice is spot on as always

Thanks GalaxyGuy your advice is spot on as always. I’m up and running with ProxKey tags

Hi GalaxyGuy, I also have prox keys, but they didn’t seem to work to set/unset. I added the serial numbers manaully via Users menu option. Thanks

Hi, Is anyone able to offer advice on the flowing: I set the alarm using + A when leaving When entering I used [code] + Ent but the alarm doesn’t unset. Instead i get the message “Status Set”. What is the correct way to set/unset the system?

Hi GalaxyGuy, Just wanted to let you know, I took your advice. Replacing the fuse and wiring as you instructed solved the issue. Thanks you

Hi, Okay i’ll try that. My bell has an internal battery. Originally i connected H+ to 12v bell H- to 0V R- to bell Bridge T to 0V This blew the fuse, although not sure it blew the fuse because i did it in engineering mode with power still to the panel. Does what I originally did sound...

Hi GalaxyGuy, Yes i’ve just checked the fuse using a multimeter as per sircerebus666 and it is blown. So I just need to connect +ve and -ve as you’ve described, will i also need to change any settings to be -ve/+ve trigger? Thanks Vin

I didn’t as I left my multimeter at home. I will check tomorrow. I hope galaxy guy gets in contact. Thanks for your reply. Vin

Hi all, I'm hoping someone can help me. I've recently installed a Honeywell G2-12 into my home. I've installed all the sensors and everything was working fine. Lastly I needed to wire the internal sounder (i've decided I don't require ta bell box at the moment). Whilst installing the internal...

Thanks Ollski, i did this setup originally but dont think the boiler or heater turned on when pressing the silver buttons in the hub... maybe i didn’t wait long enough for it to turn on (30-60 seconds)

Hi, Can anyone help me with the wiring of my programmer to hive? There’s 6 pins and Hive only has 4! Also i have two thermostats. Thanks Nay

Great diagram. Mine must be fully pumped as i have two valves, on for CH and one for HW

Hi Stem, Just to let you know. Connecting that wire worked! Thank you. Last question, what is the diferwnce between gravity fed/part pumped and fully pumped (default) Beat Regards

Hi Stem, Yes, definitely dual version as I have the two buttons. I think I realised my error. I removed the link between pin 5 and live. However, instead of isolating the remaining wire, I should have connected this to live too! I'll try this and let you know how I get on. Thanks

Evening Stem, I finally got round to giving this a try. I kept all joins (pin B & D) the same Neutral = Neutral hive Live = Live hive Pin 3 = HW on hive Pin 4 = CH on hive Pin 5 = remove bridge and isolate The hive turns on and flashes amber as per expectation. However, the CH doesn't come...