Recent content by Nemesis84

That was the key, thanks so much stem for sticking with me! Pushed the plastic rivets off and screws undone then did the Russian dolls three layers to get at the wires. Cut a kettle lead in half and ran the LN and E as it was there in one run, and then the other half to replace the thermostat...

Hi stem, this is what it looks like inside the box, not labelled unfortunately, at you saying ignore the bus as in it isn't used or ignore as in leave it in place (as there is a wire in it currently!)

Thanks stem that's super helpful! Doesn't look like much room around it to access it to open it up mind... May have to try the screws at the bottom and see if can prise the plastic rivets off!?

Good point... Appears to go to this black box! And then out again the wires on the left of the pcb. To Ext seems like it might be the one but I've never seen these wire terminators/couplers before. Also not overly apparent if I can get in the black box, has screws underneath but also those...

Thanks Stem I think that all makes sense on the thermo connection points (although I don't seem to have the same wiring config as the illustration - I can see a 24v point marked as x19 but that h=has three wires currently Re:the N&L same supply as boiler though - is there another wiring...

Thanks, a live and neutral fed from where though? ( guess this needs someone with this boiler! )

Hi All I've trawled through here and not found a thread that precisley matches my setup so rather than break rules and tag onto other posts have started this one! Has anyone got any experience wiring the hive single channel heating system to a glowworm 38cxi combi? I currenlty just have a...