Recent content by neomagik

If you mean an olive, then yes I did.

It was plastic to chrome and I used compression nevertheless I can see the joints and all is good.

Thanks, I suspected so. I guess I'll just have to wait for it to show itself because I'm out of ideas where to look :roll:

Its a Potterton Promax HE and I think it shuts down at 0.5 bar with an error code. Does this rule out a faulty gauge?

You've just reminded me, when I first noticed the pressure drop, I filled it back up, turned off the boiler and isolated the heating flow and return using the valves under the boiler. I then left it for a couple of hours and when I returned the pressure gauge hadn't moved. I then opened the...

flameport, if the towel rad was leaking above floor level I would see the water making its way to the drain. As I said before I can see under the wetroom and it's dry. Arfurrrr, yes I have tried isolating the towel rad and no difference.

Hi, I have recently added a wetroom ensuite which involved adding a new heated towel rail. For a few months while I was building it I had the chrome heating pipes sticking out of the floor with isolating valves to stop the water, this way I could regularly check for leaks before I finally...

Thanks guys, Sounds to me like the best solution would be locktite55 on the threads and ptfe tape to form a seal around the flange.

So can metal to metal threads be sealed with ptfe tape alone because I can't find a washer to fit anywhere?

LOL This is a DIY site! :lol:

Ok here's some pictures.