Recent content by Newmank15

Went with locating them where the original thermostats were. If there was anything that went wrong (typical it has done) it could be worked through methodically

managed to get round to installing and did so as per the list above, all receivers and thermostats work. However, when I turn on either the upstairs or downstairs thermostat they turn on the full heating system. Am I missing a step with the wiring or is it something that I need to adjust in the app?

Thanks @RandomGrinch I’m going to start with replacing them at the thermostats (bedroom & hallway) and then if I get a telling off from the missus I’ll look at putting them next to the control center. From reading a similar forum that @CBW responded to does the wiring principle below apply...

Thanks both for the replies! I think I follow what you’re recommending. Just to be clear, you’re saying I have all the cable I need and I should pull out the wiring that is routed to the current thermostats and refit to the receivers?

Ive bought hive multizone on a Black Friday deal and want to get it installed this weekend but trying to get my head around installing the receivers is proving tricky. I have an Alpha etec 28 combi boiler with wired Honeywell t3 thermostats (downstairs & upstairs) and danfoss zone valves. Where...