If the timber your are adding is going on top and you are screwing diagonally, I would recommend piloting the holes with a 5mm drill bit first. I'd say 70mm is a little less than ideal for this but you may get away with it. Make sure you alternate the screws on each side.
If I've not understood...
Thanks for the picture, it appears I'm missing the blanking plate from the one on the left then. Should this have come pre installed or did the plumber forget to fit it?
Hi,
I had a new Vokera vibe max 30 boiler fitted last month and I'm very happy with it so far.
According to the documentation, this is a room sealed boiler like I think most are nowadays, but there seems to be a hole in the bottom of the casing somewhere near the condense drain.
This is fairly...
Hi Jarsudsco1
Sorry to bring up a 12 month old thread, but did you ever figure this out? I just bought the same thermostat hoping to connect it to a vokera boiler that supports opentherm but the device doesn't seem to power up?
Thanks
Dale
If you go to the following url, you can download the skp files.
The ones I have mentioned are garage1 and garage2.
Garage3 is another possible idea but I think that would mean too many ridge tiles at the rear of the garage.
The scaling is not accurate, but gives a basic idea of the shape...
Hi,
I'm about to start building a garage which will have a tiled roof.
My house is on a corner plot so in order to make the best use of the space available, I would like to build it with one side out of square.
This will mean the garage will measure 12 foot across the front and 9 foot...