Recent content by NotSureHow

Thank you both for taking time to give me your feedback. You measure the depth of seal the same way for either a bath or shower trap. For example, here is a trap that states it is suitable for either a bath or shower and says it has a 19mm trap depth. If you look at the drawing it shows the 19mm...

I want to replace my old cast iron roll top bath with a new roll top bath — either cast iron or acrylic. I have been looking at the current plumbing to see what new bath I could have so that I didn’t set my heart on a specific bath only to find out that it wouldn’t be suitable, and noticed...

The hot water is from an unvented cylinder. I've only taken one of the taps apart once before - quite a long time ago to replace the washer and that was under the supervision of my husband!. There are grub screws on the handles but I can't get them to budge - probably because they are so old...

Thanks Exedon.

Unfortunately, I haven't seen any that would be suitable. This is a photo of the current taps.

I have an old, refurbished roll top bath which we installed about 25 years ago. It has old globe taps fitted. As I now have a bit of arthritis in my hands, turning the crossheads to turn the taps off and on is only going to get more difficult in the future. So, I would ideally like to change...