Microbore system, was heavily sludged. I gathered it would need a flush any way so best start with that and see if it has a positive effect on the pump, if the issue is related to that. But mainly it was curiosity, that's how we all learn.
Hi all,
I have power flushed a heating system. Boiler does not work (was not working prior to power flush).
When demand is on, pump starts, I can feel a short Puff of air from the flue. Everything then stops and cycle restarts. Very occasionally burner ignites for a few seconds then goes back to...
This switch is only activated when the hot water turns on. I can see the pin push out and press the switch. Boiler then boosts.
Do you still think I should cut it?
Thermistor replaced, but still the same.
Micro switch is activated by the vertical pin on the diverter which extends when boiler is turned on. So I assume micro switch is working fine.
With microswitch disconnected, and boiler switched to water only. Fan and pump seem to run without any...