I removed the handle/cartridge, slackened off the isolation valve under the basin and water started coming out of the cold outlet (where the cartridge screws into)
Are you thinking that 'not enough' water is getting there? (TBH, I quickly closed the isolation valve when water started coming out...
Hi all,
The cold water was only dribbling out of the bathroom basin tap.
I isolated the water and took the handles and spout off. I checked the cold cartridge, it visually looked fine but I swapped it with the hot one just in case, put everything back together but still the same issue...
Hi, my shower has developed a drip. Reading the forums seems to suggest a faulty cartridge (agreed ?). If so, can anybody identity the make of this mixer bar?
Many thanks.
In case this helps anybody else...seemingly got there in the end. Had to reconfigure the zones and reprogramme everything (maybe more trial and error or more luck than judgement rather than anything else) but everything seems to be back to normal - no errors/alarms overnight and all the zones...
Thanks, sparkymarka. Really appreciate your constructive and insightful comments and knowledge of the situation.
A bolted horse and stable doors spring to mind, but let's not digress...
Agreed...although, i thought i was asking questions before.
Irrespective, i was hoping i had reprogrammed according to pages 26-29 of the manual but the panel isn't happy with me...not sure what i'm doing wrong...
Hi handymanjo, see attached photo.
White and green wires come from door contact (changed from blue/black from previous pic incase it was the black/blue wires playing silly buggers).
Since I messed about with resetting the system, the issue has moved from the original 'tamper error' to now...
Hi sparkymarka,
Assuming I've understood correctly...2 of the 6 core wires from the door contact go to zone 1 of the PCB and one of these wires is twisted with another wire from, what I assume is, zone 2 (the hall).
I had the hump so I did a 'restore default command' (98tick at the keypad)...
This is winding me up now.
Checked resistors across door contact, they were just about in spec. Went to RS components to get new ones.
Replaced resistors and replaced the original 2 core wires with two that weren't originally being used. Same problem!
I'm running out of ideas. I've linked out...