I would describe as a wrap around P clip with a pinch bolt. I think it is copper or maybe brass?
I’ll ask my electrician if he knows.
However my first question remains
Is Ze of 1.7ohm ok?
So much higher could it be to be acceptable?
Before the CU was changed, the flat has been owned by my wife’s mum, and now us since 1994
Never had a fuse blow. Never even changed a light bulb for mum
Yes out of solid floor
Not sure it’s mounted in box 415v
Haven’t taken any since
Said it is high
Irrelevant it was test direct to the clamp that is seen
I’ve got a couple of pics before CU swap
I’ll dig them out.
Electrician hasn’t given me paperwork yet, I told him I’d like to get the bottom of problem now and then do retest
Thanks for reply
We’ve tried cleaning a polishing cable of clamp. The reading was taken direct onto sheath of cable.
If they say go TT who tells the other 2 flats?
Hi
just had a consumer unit changed in a ground floor flat that i own in Newport Gwent
Flat is fed via a cable that pos out of the floor and terminated in a 415v steel box.
One phase is then split out and feeds my local meter and CU.
The remaining cables are then fed up to the ceiling, where...
Can’t drill new hole as the led module is mounted centrally on the lamp base
Rotating the base doesn’t help alignment as the base needs to be central over the conduit box otherwise the appearance would look cowboyish if the fitting isn’t in the centre of the Artex circular pattern.
Not fussy on...
Good Morning
Advice please
I’m removing a couple of old glass/metal light fittings ( no earth connections)
They are mounted on existing 2BA screws centrally over a round steel conduit box (BESA?)
The flex is in to fitting is just off centre, but pos through and terminates ok.
I want to fit a...