Recent content by oodatdeer

Solved ... I removed 4 corner clips by inserting thin metal bar into gap at edge of door to contact bottom of each clip. Light tapping pushed clips out. Might not be the correct way ... but it worked. The door then came apart to reveal broken spring. The springs are slightly different for left...

Have removed grill door from N/W MX6 to replace a spring. Top trim/handle is removed but not sure on next step. Thanks for any replies.

No rocks thrown at criminal yet ?? ... how strange ??? Seems most people think if you turn around for a moment and your child is snatched it's YOUR fault and NOT the backstud that did it .... how strange ???

ok .... pleased you are happy now.

Dont know how old your printer is but I have heard of Epson's playing up after so many prints due to "waste ink pad cleaning" request. This has nothing to do with cartridge pads .. these are inside the printer. The counter has to be reset too. Try this for starters...

Must add ... the problem of the Drayton 3 way valve not operating automatically after power on was because the lever that is pressed in for filling had jammed at the start of travel. After removal of actuator I was able push the lever back a tiny bit to release jam and pull it out about 1/8...

Child AND parents are victims as are relatives and friends. Surprised you ARE a parent with such comments.

Persimmon ... I hope you ARE alone with that kind of thinking. The unfortunate parents have done a brilliant job of keeping this awful crime in the publics eye .... even the word eye means something now ... yes?? It's about time people stopped throwing bricks at the victim and saved them for...

ChrisR ..... eeekkk !!!! Sorry I didn't reply till now .... been in so many forums I forgot about this one .... my problem is solved thanks to you and all others like you who give their time to help others. THANKS.

Bought replacement Drayton RTS1 and discovered to my surprise that the original was RTS4??? These are for COMBI boilers aren't they? My boiler is Baxi Solo3. Could it be that the RTS4 was wired to act as RTS1 because it looks as if an extra wire loop has been inserted. Daren't plug new...

giblet ....(thanks for reply). I replaced motorised valve and set it for refilling. When the valve is powered it is supposed to click into normal operation automatically ... it didn't ... I then noticed the thermostat did not make faint click when temperature knob was turned to both extremes...

Bought replacement Drayton RTS1 and discovered to my surprise that the original was RTS4??? These are for COMBI boilers aren't they? My boiler is Baxi Solo3. Could it be that the RTS4 was wired to act as RTS1 because it looks as if an extra wire loop has been inserted. Daren't plug new...

Softus .... Thanks very much for prompt reply ... will replace.

Hi ... first time here ... be gentle with me. Have just fitted new drayton 3 way valve. From new, a lever is pressed to ensure system fills correctly and should deactivate to normal use when current is applied. This did not happen ! I am sure it is wired correctly. However, I have noticed that...