Recent content by oriontc

  1. O

    Vaillant ecoTEC 824e hot water going cold....

    thought id reply and tell you all I had it power flushed and now it works perfectly. water is nice and hot. i did also fit a flow reducer to the shower which must help a little. but the flush did it the world of good. flame stays on high now. cheers all!
  2. O

    Vaillant ecoTEC 824e hot water going cold....

    Correct if I turn the bath tap down it stays hot. The flow from the bath tap is around 9-10 litres a min on full flow. The boiler is in the loft which prob doesn't help with the heat. So is the hissing sound normal? Is it just a case of the water is too cold to warm up quick enough for...
  3. O

    Vaillant ecoTEC 824e hot water going cold....

    ok i made 2 youtube videos to give you an idea of the sound etc and what it's doing. the code both times was S.14 Boiler when bath tap running http://www.youtube.com/watch?v=ETa8UJZ4njE you can hear the hissing, and the water is luke warm. Boiler with bathroom sink tap running...
  4. O

    Vaillant ecoTEC 824e hot water going cold....

    excellent, ill try that cheers
  5. O

    Vaillant ecoTEC 824e hot water going cold....

    will there always be an S code displayed? ill give it a go though when im at home.
  6. O

    Vaillant ecoTEC 824e hot water going cold....

    Hi all, ill try to make it as short and straight to the point. normal central heating works fine. when I use the hot water from the bathroom sink tap the boiler fires up on a full flame then stops, then starts again after a few seconds back on full flame. so its very on and off, it doesnt...
  7. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    According to the boiler there is no error code when it goes colder. The boiler appeared to be on constantly while the hot water flows. Any ideas? We tried pressing the i button and no code came up.
  8. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    do you think it is the shower though? considering the kitchen tap goes cold after a couple of minutes too?
  9. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    The shower only has one dial. It turns on when you change the temp gauge so I can't change the temp without the shower being on? Unless I'm missing something
  10. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    i tested a couple of things today. downstairs kitchen tap went cold after 2 mins, i left it running barely warm for the next 4 mins and it never picked up again when i turned the tap off after 6 total mins. i then left it for a good 5 mins turned it back on and more hot water came through...
  11. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    ill try both ideas and get back to you when im home, cheers!
  12. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    i turned the hot water up and it did seem to go up into the 60's on the boiler itself. the programmer is a vaillant yes i can control the heating using it and it has a temp sensor. i never touch the "hot water, (pic of a tap)" side of it only the "radiator (pic of a radiator)" heating side...
  13. O

    Mira 415 shower + Vaillant ecoTEC plus 824 = cold showers...

    Hi all I have been living in my new home for around a year, during the summer the shower is fine, keeps warm/hot for as long as i need, i realise partly due to the fact it is naturally warmer too.... When it comes to winter the shower goes cold after around 3-4 minutes. at this point I have to...
  14. O

    Can anyone identify this roof guttering please?

    part of it has broke off and im looking to replace it, can anyone tell me what make/model etc it is? thanks in advance.
  15. Untitled

    Untitled

Back
Top