They are TP5000. Yes one in the living room and one upstairs. There are three valves by the hot water tank. Two white ones (zones?) And a third which is definitely something to do with the hot water as I can hear it moving.
Stem,
Thanks for your reply, and more importantly your patience!! I have brought the hive from a previous home were the installation was relatively simple!
From what I gather in my new (new build) home, it's a two zone set up. There was/is the dafoss ts751si by the boiler controling the over...
Confirmed my suspicions. I've only wired the one in by the boiler. It's a danfoss ts715si, I've obviously mistakenly assumed it was a straight swap for the hive dual channel receiver. Do you have any ideas on how it should be wired in?
This seems to have set my boiler to permanently on. The boiler is fired up although both the upstairs and down stairs are set to off, and the hot water is also off. There are also no lights lit up on the bolier control indicating that the boiler should be on.
Stem,
Thanks again for the reply! I've connected the live and the black and isolated the neutral at the thermostat. I'll have a look upstairs Tomorrow in daylight and see if I can find trace the wiring.
My situation seems to have become a little more complicated. The hive boiler control downstairs seemed to be working fine, but in actual fact it wasn't. I think I need to bypass the old thermostat, is it just a simple case of joing the live and black wires together and then using the hive...
Ah, I understand now. So it's just a case of chasing the thermostat wires from the bedroom back to the wiring hub. Do you know if I can use a dual channel receiver, or should I get rid and it and get a single channel one? Is there a way to by pass the dual channel element?
Stem,
Thanks for that. I think I'd like to have the receiver hidden and the stat on display. My issue is now the wiring from the wiring center into the hive receiver. Is it the valve that I should be wiring in, or something different?
Stem thanks for the reply. Yes zone 1 heating and hot water down stairs is working. I replaced the boiler control with the hive receiver and have disconnected the original thermostat and I'm using the wireless hive one in it's place.
I've read on other posts that I should be wiring my second...
Hi there.
Hoping for a bit of help. I have a danfoss multi zone system and want to replace it with a hive. I have already wired in the control by the boiler and both heating and hot water seem to be working fine. I'm struggling upstairs with the WB12. I've worked out which valve controls the...