Recent content by PatrickJD

Thanks for replying. I don't have any issues with Hot water. When the heating comes on, it comes on for about 10 seconds, then goes off flashing E117, then goes off and comes back on 3 seconds later. (I've turned off heating for now). In terms of over-pressurise, I've not done any pressure...

So the 2 back ones (bottom of picture) are closed and should be open, and the 2 front ones (top of picture) are open and should be closed. However, with the current settings, this closes the loop anyway so isn't the cause of the high pressure, is that correct? Thanks

Hi all, I've had low pressure on my boiler a few times and just used the filling loop to sort it. However, now I seem to have a high pressure isssue. I've managed to get it out of the red by bleeding from a radiator, but as part of the checking the issue I've looked at the filling loop and I'm...

Thanks for the reply. So basically replace the Siemens receiver with the Honeywell receiver as is (but change G/Y sleeve to Brown) Boiler is a Baxi Neta Tec Plus 33 The Thermostat is this one: Honeywell Home T6R Wireless Smart Thermostat — W-iFi App-Enabled to Save Money and Improve Efficiency...

Hi all, need some advice. I've got a Combi boiler (Baxi) which has a wireless thermostat setup (Siemens RDJ10RF and RCR10/433-GB). I'm looking to replace it with a Honeywell TR6-HW Wireless setup. It looks fairly straightforward but the wiring currently installed looks different from the...