Recent content by paull01

  1. P

    Ford Ka stalling at junctions

    Thanks Neo Car was last serviced about 6 months ago - Do you know if the throttle body is easy to get off? Cheers
  2. P

    Ford Ka stalling at junctions

    Hi, The engine on my Ford Ka stalls when slowing to a stop at junctions. It has got progressively worse over the last few hundred miles and now it happens every time I stop. The symptoms are: It usually happens when I'm slowing and depress the clutch It only happens when the car has warmed...
  3. P

    Latex-based wallpaper adhesive for Mylar paper?

    We have just bought a roll of handprinted 'Mylar' wallpaper that specifies in the instructions it is best to use a latex-based adhesive that you paint onto the wall instead of the standard wallpaper paste onto the paper. Does anyone know what I should be looking for here? is your standard...
  4. P

    Is there a recommended max length of flex to storage heater?

    Thanks for the response Berhard, The floor is strong enough as it is all concrete flooring. I'm getting the feeling though that it is best to get a professional in to do the job - it seems extending the cable is going to be the best option... Many thanks
  5. P

    Is there a recommended max length of flex to storage heater?

    Hi Guy, thanks for the response I could rewire the cable instead of the flex but this is currently going through a number of rooms (through enclosed boxing) so it would be vastly easier to replace keep the isolation switch where it is, move the heater (approx 6 metres) and wire with a new...
  6. P

    Is there a recommended max length of flex to storage heater?

    I have a storage heater (large with bricks) and I'm intending to move to the opposite side of a room. As the cable routing back to the fusebox is quite long it seems to be a lot easier if I just replace the flex from the switch to the heater. This means the switch will be in one corner of...
Back
Top