Finally got round to doing this job and your technique worked a treat:
Used the 5" and wrapped some old rags round it and slotted inside the 6" bit so it wouldnt move and got the hole started and then could take the 5" off and finish the job
Just to say again thanks for the help with this...
Kevin - Im trying to work out in my head the configuration do I need a very long thread on the arbor to go through both the 5" and 6" bits
Thanks if you can help
Hi hoping someone may be able to help.
I have a 5" diameter round hole in a double brick exterior wall in my second floor flat, I am looking at installing a 6" diameter fan in the same position.
Due to access limitations Id like to be able to do all the work from the inside of the...
I bought my flat last year and the boiler worked ok but stopped working a few months back. I paid for a new PCB which for these boilers are over £200 just for the part and the boiler has worked ok but while it is still working I am considering getting a new one. I'm not sure of the age of the...
im not in the plumbing game so hope I'm not going to have to fork out alot....do you have any experience on Ferroli boilers are they any good? This was in the flat when I bought it
I have someone coming round Saturday morning to give me his opinion and am hoping its just a seal etc...think will be able to limp on until then and hope to get it sorted out.
Lots of water came out during the night...
Thanks for everyone who gave their input I will advise back when I...
I will try to do this not sure exactly what im looking for possibly a leaking valve etc....might have to wait till the weekend but thanks very much for your prompt response.
I have spent a bit on this boiler already due to a PCB fault, so hopefully its something simple.
Cheers again
Hi I have a Ferroli 901 boiler which I had serviced around 3 months ago. I have noticed recently that quite large amounts of cold water leak from the underside (there is a small hole at the bottom and this is where the water comes out )and was wondering if anyone knew what this could be?
I...
Cheers lads - the missus blowing down my tube tends to make everything better!- have given mate the go ahead to replace PCB so will let you know if that sorts it. Was thinking of replacing boiler anyway but given timescale and temperature ill have to do this so got my fingers crossed it does the...
Ok so answering my own problem here but LED 5 (Red) is showing as Red when I try to get DHW so I am assuming this is a PCB fault as in the manual it says: waiting time, replace PCB.