Recent content by pemba

Guys thanks again for the feedback. Motor was exactly right, the new pads won’t fit over the seized slider. Thanks again for all the valued input.

Guys many thanks for the responses, good discussion as to how to resolve the seized pin. However, the question is do I have to fix the pin? Does it being seized have a negative effect on the operation of the brakes?

I thought of using a socket but the head is rectangular so I didn’t think a socket would fit snugly. Great idea, thanks.

Evening guys, as usual I’ve got a question. Currently trying to get my son’s 2005 Corsa C with 90K on the clock (so it’s not going to last more than a couple of years at best) through it’s MoT and I’m replacing the front discs and pads. When I’ve stripped it down one of the slider pins in the...

Pictures of the wall.

Thanks for the responses guys. Proper coping stones look great on a brick wall but this is an old stone wall. I think new coping stones would look out of place against the old stone wall. Any comments on my queries? AndyS

Hi guys after some advice please. I have an old garden wall which has been left exposed the elements for a few years allowing moisture to penetrate and weeds to grow. I’m currently relaying the top course of stone with the aim of laying slabs on top to seal it. The wall about 375mm wide. A few...

Thanks for the advice, have you used the Halfords etch primer? Struggling to find another locally and need it for tomorrow once the wheels are blasted.

Hi guys I’ve just picked up 4 steelies from the scrappy and dropped them off for shot blasting. I’m then going to hand paint them. I’ve been advised to wash them down with cheap thinners prior to priming and painting. Question is can I use any wood/metal primer or does it need a special primer?

Final update, it was of course threaded and it was my stupidity trying to undo it thinking that the red collar was part of the elbow when it is of course part of the hose. Many thanks for the helpful advice guys and apologies for being dumb.

After trying to loosen with a pair of Stillsons it’s still not budging. I’m now leaning toward it being a push fit as Alec_t suggests (it certainly doesn’t look like a thread where they meet). I’ve tried pulling the red bit to the left but no movement. Would water pressure be holding it closed...

Defo anti clockwise and defo won’t budge ‍♂️ Sure something will give and, as it’s bust anyway, nothing to lose with more pressure.

Good morning guys looking for some assistance please. Dishwasher is throwing an i30 error indicating it’s flooded. Trying to remove the dishwasher but struggling to undo the cold water inlet. Please see attached photos. I am unable to unscrew the red plastic female portion from the stop valve...

Good morning guys after some advice as usual. I intend putting up a 6 foot garden fence and gate at the end of the driveway to the house. The main reason is to ensure a secure place to leave our new puppy (German Wire Haired Pointer) who appears able to escape from anywhere. The construction...

Many thanks guys, great inputs. I’ve repaired the “nicked” cable on the OEMs charger. Bearing in mind it is constantly connected I’d rather be on the safe side.