I have some new taps which came with flexible pipe tails. The O-ring end goes into the tap block, and at the other end there is a captive screw connection with a washer. What should this connect to?
I thought it might be a 10mm compression fitting, but it's too big for that (and too small...
Thanks for that. Unfortunately a new hole in the wall for the wm waste would be tricky due to inaccessibility.
However I was wondering about connecting to the sink waste which is alongside. Presumably with the right sink trap the wm waste just plugs onto it?
I'm plumbing a new washing machine and am tapping into the existing sink waste via a new open trap with U-bend. The existing waste which I am using is about 400mm up, so there is only room for a short vertical length of waste pipe below the worktop. Does that matter?