Recent content by Phillip73

  1. P

    Heatslave 12/14 lockout

    just to make sure the pump was getting oil i loosened the bleed screw after resetting the lockout button, no oil was passing threw the pump which means the motor isn’t spinning, I’m hoping this is down to a faulty capacitor but won’t know until it arrives and it’s been sent over from Northen...
  2. P

    Heatslave 12/14 lockout

    Thanks I didn’t think it was right.. Out of curiosity, does anyone know how the order in which the motor fire up? Does the solenoid on the pump and the motor get a signal to fire up at same time or will the motor turn the pump… My motor is a bentons 70w but struggling to find a 70w on the...
  3. P

    Heatslave 12/14 lockout

    Iv had to take the whole ignition out to get the capacitor unscrewed.. I’m not totally sure if my multimeter is set up for the correct reading so I’ll get the capacitor changed and see if that does the trick..
  4. P

    Heatslave 12/14 lockout

    so I’m guessing the capacitor will supply the starting motor which when working will turn the pump etc? I’ll change the capacitor first and if no joy i’m guessing it’ll be the actual starting motor? I may have to call an engineer to test that unless I just replace it aswell…. It’s been a...
  5. P

    Heatslave 12/14 lockout

    thsnks again John, Iv got an amp multimeter which I checked the capacitor with but not sure if I had the meter set to the correct setting. I got a low reading on the capacitor of 0.30 but not sure if I had the meter set correct?!
  6. P

    Heatslave 12/14 lockout

    morning John, the capacitor is difficult to pull out without taking the whole unit out as my fingers don’t fit .. so you recommend loosening the 3 screws that hold the pump in place? for what little the cost I’m happy to replace the Capacitor and pump as they’ve had a long life up until now ☺️…
  7. P

    Heatslave 12/14 lockout

    Morning all, Iv been having several lockouts on my heatslave 12/14 in the past 2 days and after replacing a thew obvious parts it’s still locking out… Iv replaced the ignition unit, solenoid and control unit.. When pressing the reset button the burner will make a humming noise but won’t fire...
Back
Top