Recent content by phoenix79

Thanks guys, much appreciated. Should I be concerned with the cracks at the corners on the window below? Also possibly not related but a gap appeared between my staircase and this same wall, it reached a little over 10mm ( I could get my fingers in) my solution was to apply a wooden bead over...

Hi, I live in a semi detached house, I have just been in my attic and I have a crack in the thermalite brickwork wall on the gable end side this goes from the top down below/behind the plaster board wall. Certainly top to out of sight. The crack doesn't follow point lines but goes straight...

Changed the valve today and im up and running with heat GRRRRRREAT! as Tony the Tiger would say. :o :o :o :o :o :o :o

Hello again, right i checked everything and no wires are loose so i bit the bullet and decided to bridge the connection basically running a wire from the grey in its current terminal to the Orange in its terminal. Guess what the CH on its own came on "Result" on thing is it doesn't seem to...

If this is the case. Could i bridge from the grey to the orange skipping the microswitch, inorder to save my heating system until i can get a new valve fitted????

The valve clicks into CH position when there is a call for heating but no responce from boiler or pump

the programmer failed as it stopped turning both the heating and the hot water on

The back of the new programmer is set to pump fed. Still no joy =0(

Hi i am having the exact same problem and i do not have a clue if you do find out please let me know. Likewise if i find out i will post you. :wink:

Hi i recently had a fault with my programmer that controls my boiler for heating and my hot water storage. I had the ACL Life style LP241 so i replaced it with a Sunvic 720XL the wiring diagrams are the same and it actually listed on the instructions that it is a direct replacement so i need...