Recent content by pvr

  1. P

    Ceiling lights + loft insulation

    I have a lot of lights in the ceiling (low voltage, 50 Watt). The other side of the ceiling is in the loft itself. So to allow for the heat of the light to disperse at the rear of the light, I have cleared for each light, an area of loft insulation material so that the light is clear...
  2. P

    Fitting dimmer switch in 3 way circuit

    1700W ... wow, is there such a dimmer? So in other words, it is not possible to get a dimmer anywhere in this setup?
  3. P

    Garage Ceiling

    Yes, on top of the joists I put a MDF board (water resistent) floor. Underneath it (i.e. between the joists) I put 10 cm of that white insulation material that you can cut to size. Just never considered to check that the bottom of the joists were not equal size as the top (where the MDF...
  4. P

    Fitting dimmer switch in 3 way circuit

    I have a 3 way switch circuit in a room which has 17 50W low voltage lights on them. Can I replace the intermediate switch with a dimmer switch - and what would that dimmer switch be called? If it exists, would a 1000w dimmer be needed here. Thanks for your help.
  5. P

    Garage Ceiling

    In the garage, I want to sort out the ceiling which is proving a bit difficult. The joists are not all the same height (measured from the floor) and I have boarded the ceiling using plasterboard. However, due to the joists not being quite the same, the ceiling has a few bulges in those...
Back
Top