Recent content by r0by

How did you get this sorted in the end? I have exactly the same issue a toilet with 2.5 inch hole did the fluidmaster fit or did you get something else?

yeap they are just connectors wrapped in tape. Do they need to go in a junction box by regulation?

yeah I had a quick look last night and it didn't look like it would be that easy to cut a hole out. I might just try pick out some plaster board stuff all the connectors up into the hole and then fix the base plate which should give me enough room.

that's what I needed thanks for the advice. :)

I've removed an old light fitting with 4 GU10 downlights from the kitchen which had a large base: https://www.dropbox.com/s/2wuq8qou8mbhp36/Photo%2009-12-2012%2015%2036%2008.jpg The connections in the ceiling have a lot of connectors...

yeap your right it is a bit of a tight space I'd try to keep it going for a while if it's not too bad. Would pouring some of this stuff into the header tank help against limescale with one of these and how much would I need...

I'll monitor it and see how it goes. If I do need a new tank do you recommend anything better than a gledhill torrent as this is supposed to be 3 years old and I've had nothing but problems!

So as long as the expansion tank has even a litre of water then it should be fine? The problem is that the ballcock is blocking not the valve it's only been a month since it was replaced and it was fine. Maybe it's the coil leakign slowly and that's quicker than the evaporation. I guess I...

I've turned off the feed into the expansion tank and the water doesn't increase. If I turn it on then then it comes out like a tap at full pressure. Sorry for the following stupid question but why do I need to let water in there from the mains if it's just gets water from expansion? What is...

Hi, I moved into a flat which has the following "Gledhill Torrent Direct T210 DE" thermal storage store to provide hot water...