Recent content by raja

thanks guys. i have solved my problem by changing the water turbine and the flow sensor. it all works beautifully. thanks to all of you.

i didnt know there was a limit on having more than one boiler. Thanks any way.

Hi Guys, Please help me with Sime eComfort 30HE combi. On DHW demand it comes on going through the whole lighting up sequence. The burner comes on after few seconds the burner goes out and the top LED goes red and locksout. I have to reset the boiler from the fuse spur switch by switching it on...

Hi Guys, can any body help with the no hot water problem on glow worm betacom 24c. i have replaced the Thimister on the DHW side. The burner comes on for a short while then turnes off, but the fan continus runing no warning lights comes on and it does not go to the lockout. I have cleaned the...

The clip on clip got the small PCB built in it, I think it reads the current flow from the water turbine when the water flows through it hence sending the signal to the main PCB.

Hi mate, the problem (blockage) is not the hot water side it is on the primery circut side in the plate heatexchanger. You be better of replacing the Plate Heat Exchanger as descaling the plateheat exchanger is not easy. But thats not to say it is impossible.

Thanks Toney, Yeah there are no warning lights other then the power on GREEN light. Is there any way i can check the clip on sensor for the function? Do I have to replace the Turbine and the sensor or just the turbine alone will do?

Hi Friends, can some body help me with Heat Line C28 working ok on the heating mode but no Hot water on demand. My feelings are its thr cold water turbine clip on sensor. Please let me know if any body experiance the same problem and the solution for the problem will be greatley apriciated...