Ive checked the voltage on the control panel and goes up to approx 13V when alarm is triggered. There is no time delay or double knock on the PIR's...hhhmmmmmm
I'm still having no joy with the wiring to the bell box, the strobe works when i test it from the control panel but still no alarm sound, i'm sure i must be wiring it up incorrectly or doing something the may require putting one wire somewhere else.
I've tested the system, the strobe works and the 2 red LEDs flash ok on the siren just the siren doesn't sound when the system is in alarm state, any ideas?
According to the manual for my ADE Gen 4, when you Enter the program mode and enter the walk through test, i get a beeping tone all of the time instead of a tone generated when each zone is activated, anyone experienced this? The zone light lights when its activated so that part works.
Mark
I have just swapped my alarm panel over from the old Logic4 to a Accenta ADE Gen 4. All the wiring bar the external bell has been connected all ok. I'm baffled to how i connect the external siren up.
Logic 4 board....Bell......+ red, - black; SCB T Green, A yellow; Strobe + Blue - White...