Recent content by redpis

  1. redpis

    Pyronix cloud, cannot add a camera

    I had the same issue, the time on the cameras needs to be synchronised to the Pyronix time server
  2. redpis

    Hive on a split system.

    It’s not that complicated, the hive controller replaces the existing programmer, the wall thermostat is shorted out and the hive wireless thermostat communicates with the controller. You don’t need to go into the wiring centre, it can all be done at the programmer end unless you want to...
  3. redpis

    Viper GLX with Contact - Am I going MAD

    Solved, my own fault using a stronger magnet also pulled in the reed relay when testing, oh well, back to rocking on the porch!
  4. redpis

    Viper GLX with Contact - Am I going MAD

    Hi Viper GLX with integral contact, I have had two from the supplier, and each one is not doing what I know it should do, so I just want a sanity check: 1) With no power applied, the alarm cct is closed circuit when a magnet is placed near the reed, I thought that removal of power would...
  5. redpis

    Scantronic Downloader Software

    I have upgraded from my old Windows 98 alarm lappy to Windows 7, installing Cooper Downloader MkIII which I use for my Scantronic 9853 panel, however, I can no longer print account info. Is their a newer version of downloader or programming software for a Scanny 9853 that you can point me to...
  6. redpis

    Advice on external hot tap

    Hi Guys, Thanks for your advice it has really helped me decide what to do. Cheers
  7. redpis

    Advice on external hot tap

    Hi, I have an existing external bibcock which is cold water only, due to restrictions in space on the external wall, adding a separate hot bibcock is not possible. I need to be able to switch from cold only at the tap when needed, but the more frequent usage will be blended water for filling a...
  8. redpis

    Unvented hot water Shower not that hot

    Well finally got round to getting this sorted after it got so bad and the hot water pressure was next to nothing, first job was to cut a square section of flooring on the landing to expose the pipes to the shower, after running the cold on the shower and feeling the pipe, I marked them so I knew...
  9. redpis

    Unvented hot water Shower not that hot

    I opened the shower unit up yesterday, the installer had removed the temperature limit plastic stops so the temperature could be up to 50C, they must have known they had plumbed it incorrectly! The shower used to work ok, my assumption is the incoming water pressure has been increased due to...
  10. redpis

    Unvented hot water Shower not that hot

    Hi Twgas, The pipe going up is to the expansion vessel, it appears the cold water feed to the shower is not tee'd after the pressure reducing valve. Checking the shower drawing it looks like isolating valve elbows are used, I might try and gag the cold feed a bit to see if that helps...
  11. redpis

    Unvented hot water Shower not that hot

    Hi, We have a an unvented hot water system and recently the shower is not as hot as it could be (the shower control has always had to have been turned all the way to hot to get it right - their has never been a good balance point) The question is, can the shower control be finely adjusted...
  12. Untitled

    Untitled

  13. Untitled

    Untitled

  14. water

    water

  15. redpis

    Hot Water Pressure Tank(?) Burst

    http://www.youtube.com/watch?v=9bU-I2ZiML0
Back
Top