Recent content by ReeceT

Cheers. So it's just under 2".

Thanks Andy. Yes that would fit the shower end, but then I need to check if it would accept a 50mm waste pipe either push or solvent, if not will be looking at some sort of reducer type thing.

Thanks, yeah that is the exact chart I was using. It was just from VidaXL.com so nothing special. The sleeve is a good idea.

Hi, the ID is 44mm and here are a few pics. Might just go and but a normal round one if this proves to be complex.

Hi there, I am sure I am not the only one who has come across this issue so was hoping the helpful chaps on here could help. We are installing a shower and the shower waste fitment has a 49.1mm OD (tapered up to about 49.6mm) connection. This doesn't seem to fit any pipes I can find. Could I...

I think they would have to be rendered to some extent, although I presume this could lead to blowing in the future. Is there a way to minimise the bubbles to achieve a 'smooth' finish...

Hi, We are looking to landscape the garden and part of this is to have some planters up the side, the designer has spec'd sleepers then painted dark grey, the wife does not want sleepers and instead would like concrete planters as these can be smooth sided and 'fit in' with the rest of the...

Hi, I am looking for some advice on a couple of questions. I have set down a concrete screed for the installation of some Porcelain tiles, the screed only went down yesterday so the first question is how long do I need to wait to begin tiling and do I need to do anything else to the screed...

Hi, I am looking to stain the outside shed with the Cuprinol colours in cream. The issue is that the last person to paint the shed only used blue gloss paint and this is now peeling. I would assume that I need to get all of this off as the other paint is a stain. As the paint is peeling...

Cheers for the quick response. Guess it will be more than a 10 min job now. Good job the wife kept the old roll of wallpaper, chisel and hammer here i come. :P :P

Hi, I am currently changing the old thermostat with a new one and have a couple of questions. The old one only has two wires from the boiler (its a Icon 23T, it will be replaced in the near future). From the manual it says it is a volt-free switch, which is fine. The old thermostat is...