Recent content by revolver10

Screwed

They are yes. I do have one door contact (out of 3) which seems to work fine and mounted in the same way as the 2 which have the tamper fault.

The door contacts are the GHA-0001 i.e. the standard ones which you get with the wireless kit.

Thanks @sparkymarka! any thoughts on the issue with the door contacts showing tamper fault? Also, should the sensors have the LEDs glow upon movement outside of arming mode? All of the LEDs on my sensors appear to be off, but not sure if there is a setting to bring these on.

Hi all, Im setting up a Premier Elite 64 (all Richochet sensors) for the first time and seem to be running into some issues with the setup/config. Perhaps, i'm doing things in the wrong order and just hoping someone can point me in the right direction. A few issues spotted so far: 1) 2 of the...

Will do!! Thanks for your help.

Hi, Yes i am gas safe registered. Waiting for approval for entry into the combustion chamber. The fan was an unrelated issue which i had repaired over there previously. I just thought that i would add that the fan was relatively new so it was unlikely to be an issue in this particular case.

Hi all, I'm currently working on a Biasi Riva Compact M96.28SM/C. The boiler doesn't seem to fire up however. The fault lamps (Left flashing green, Center Red, Right Flashing green) point to a Lack of burner ignition (no ignition signal from the full sequence ignition device). It...