Recent content by ricka

hi, i,m no expert but it sounds like the pump isnt operating,maybe something jammed in it like a coin etc.you would have to remove it and check it.ive had problems before with our washer and found the same thing :) hope it helps :(

hi, is there anyway you can mount the/ a switch just outside the bathroom door to make it safe and easier :) but then again you might as well put a pull cord in the bathroom.

hi mate you can feed it off a ring circuit with a fused spur :)

hi mate. are you sure they have,nt been disconected from the mcb,s,not just switched off and taped up :)

the BS6231 cable will be fine its rated to 105 celcius.it will never reach that temp in the control panel.if your concerned about the colour you can get some red heat resistant braid to cover the cable from R.S or maplins :) if only short tails i,d cover them with some red shrink tube. hope it...

does it have a separate neon iside it to illuminate it at all? :)

maybe the start winding on the compressor leaking to earth or inside the freezer if it has a contol switch, water getting behind the gasket. :)

hi everyone :) it depends how long the wiring has been there,if its an old installation,it would be worth testing it,not just to find the fault :) but to find out if its sound.i,m sure the fault would show up on the tests :) and maybe if you did get a sparky there, they would probably change it...

looks like a normal day on corus :D

its the only way you,ll learn getting thrown into the deep end :)

hi, within the gland kit there is a brass washer with a eyelet on it,you need to attach this under the gland nut as a washer and attach a earth link cable to the earth treminal in the cu,put a ring terminal at one end of the earth link cable and bolt to the eyelet :) this will give you earth...