Recent content by Rob Bagshaw

Thanks for your reply - So as a self install you don't think i will have too many problems

At the end of last year I was unfortunate to have a house fire in a part renovated house. Due to the fire many of the alarm wires were damaged. I can't replace them due to sensor locations. I have been recommended the above system. I need panel / remote keypad 5 sensors 1 dual tech 2 bell...

Hi, I've just checked the wiring and it appears correct. I have also put 12v across the bell box and still nothing. Looking at the 5 jumpers they are as below going horizontally down. - first one is to the right - neg - the second is to the left - applied - the third - has nothing - the...

Hi, I've just managed to check the wiring and I had it right. I have tested for 12v at the bell box and it's there. I have put 12v across the bell box on the ground and nothing - led's do nothing. There are five jumpers running horizontally. The top one is to the right showing - neg The...

Thank you very much for all your help. I have used forums every now and again and received great advice. Thanks again. Rob

Ok, Can't do it until the weekend but I understand you far more than Optima. The battery was already fitted on a plug in lead - will it not already be enabled? Just for my knowledge I don't have anything coming out of the strobe connectors as I don't have enough wires. Thank you very very...

I therefore must take the link out between A and T

Plus doe I leave the link in across A and T Regards Rob

That's brilliant but can I have one for the other end too!

Optima G4 Panel 19 Strobe + 20 Strobe - T It states under T and A SCE - and they have been shorted out. A D + under D and B it says Bell. B - Delta Plus Bell Box Tamper Tamper - it appears I may require a link to 12v - Eng Hold STB - Bell - 12v + 12v - I hope this is good enough - I don't...

Sorry that is incorrect - the tamper in the control panel just look shorted out

Thank you very much for your help. It is a Pyronix Delta Plus box. Could you please show a little diagram to help me. I thought the tamper in the bell box just looked like it was linked out.

Could somebody please help. I have tried to help the old gentleman next door and its turned into a bit of a disaster. He has an Optima G4 panel and an ancient alarm box. I have changed boxes before but when I took off the old bell box I was only met with four wires. Two to a siren and two to a...