Recent content by Robbot

Mine is not shared, and the blockage if there is one may be on my property or theirs. So unless I can establish where the issue is I could be landed with the cost.

I did, and nearly had an heart attack when they said what it would cost. They advised to do all I can to eliminate any blockage on (or under) my property first, then call them. Hence why I've tried to measure the distance and direction. From my kitchen sink to the edge of my property by the main...

Public Road. The distance between my gully and the property boundary is around 5 metres , I've managed to get a thin rod that far downstream and can find no resistance. From then it is around 3 meters to one of the first round manhole covers which access the sewage. (18 houses in one small...

I'm unsure where that is.

THe inside of the gully has been cleaned to the point you could eat your dinner out of it. The outgoing pipework runs for around 3 metres before it joins the main pipework into the road. Rodding suggests it is clear ???

Kitchen waste to bottle gully, then off to foul / rainwater waste (or whatever its called). It's been in service since the house was built 24 years ago. Over xmas I noticed the water wasn't draining from the sink when the washing machine was emptying (it had done for many years prior), so...

I'll get that organised. I'm more curious now as to what is going on.

The installer fitted the PRV, so the back of it is against a solid 6 inch brick wall :(

This is directly related to the hot supply. The cold supply does have an issue, but it's of my own making. I installed high pressure plain mixer taps in the basin, shower and sink, which all work together fine -even when the hose pipe and cistern are using water. However, the bath has low...

To replace the 15mm with 22mm would have required pulling up (or at least cutting a channel in) the subfloor across three rooms. The budget didn't run to that amount of work unfortunately. I can tap into the 15mm cold feed under the airing cupboard floor, blank of one end and connect 22mm from...

The installers didn't make those checks. However, Anglia Water took a measurement a few years back (before the unvented tank install) and they said it was just over 3 bar and normal for the area. The cold water pipe is 15mm from the stopcock to the kitchen tap, bathroom tap, and cistern. Then...

A year back I had a new unvented cylinder installed to replace an old vented one. As you can see from the attached diagram, no balanced cold feed was taken from the back of the PRV. The cold feed that supplies the kitchen and bathroom remains as before, and the fitter took the existing feed to...

It feeds an EV charger and the garage. Maximum draw on a high use day would be circa 55amps at most. Average around 32amps.

The fuse in the meter box is 100 amp, the RCD in the CU fed by 16mm tails is 80amp. I should add that the other two CUs are fed by 25mm tails and have 63amp RCDs. Hence why I asked. But looking through the posts, its looks nothing to worry about :)

I have 100amp DNO fuse feeding three CU's. One of the CU's is fed with 16mm tails and contains an 80 amp RCD. The tails are around 1.5m in length and go through the cavity wall with batten insulation. Do I have a potential issue with this set up, or should the 80 amp RCD be replaced with a 60...