Recent content by Robert_123

  1. R

    Garden shed, single skin Celcon blocks

    Hi, I'm looking to build a potting shed in the garden, with a lightweight lean-to greenhouse on the side. The shed itself will be about 2.4m square, with a 1m wide door-way opening at the front, 1m wide window on the left side and 1m wide door way on the right side that will lead into the...
  2. R

    Roof design for extension

    Roof design aside, I'm considering whether to have the inner skin of the second story built in blockwork, or to have a go at building it timber framed myself (purely to save cost). The outside will be a brick skin in any case and the existing cavity is 50mm. If the inner skin is blockwork then...
  3. R

    Roof design for extension

    It's mostly normal (square) with the exception that the wall plate at the back will be about 1m lower than the wall plate at the front (reason being is that the back wall of the garage is set back from the house and I want to keep the same roof line at the back, so I will need to drop the wall...
  4. R

    Roof design for extension

    Hi Tony, thanks for your reply. I could use a 12" x 3" purlin but I would still need to satisfy the BCO that it was sufficient - hence looking for a standard table or similar that details purlin size vs span. The loft space will have fiberglass in between and across the ceiling joists. Is any...
  5. R

    Roof design for extension

    Ok, thanks. I was hoping there might be another table that I hadn't found that would cater for longer spans (similar to the TRADA tables detailing floor joists, rafters, purlins etc). The maximum permissible span for purlins seems to stop at around 3.5 meters using a 9x3 timber. Apart from that...
  6. R

    Roof design for extension

    Hi Woody, thanks for your reply. This will be my third DIY extension with a cut and pitch roof so although I will be drawing plans and getting full plans approval, I'm hoping not to need an architect. I like the idea of purlins on struts on timber beams (I presume that this timber beam would...
  7. R

    Roof design for extension

    Hello all, I am new here so hoping this is in the right place. I'm looking for some advice regarding timber sizing for a roof: I plan to build a room on top of an existing attached garage. The overall dimensions will be 5.5m wide x 8m long (brick and block with 50mm cavity). The room will be...
Back
Top