Recent content by robroys24

Hi rock1 . i would like to say many thanks for your help mc now up and running again all ok . Thanks again regards Robroy

many thanks ill try that .1 more question do you have there site ? cheers Robroy

Hi Rocks1. Thanks i took the wires off and tested the heater and it buzzed and gave a figure of 31.3 Is there anything else it could be as i tried it again yesterday and the same thing happens it fills so far goes off and looks and sounds good then a few minutes later it starts to put more...

Thanks for that ,i bought a multi tester and did the continuity check and i put the test leads on the heater terminals and the buzzer went off and this happened when the m/c was off or on . Does that mean the heater is u/s ? Thanks Robroy .

Sorry to trouble you again ,but what can i check it with ?. Many thanks Robroy.

Thanks rocks1. ive checked the waste pipe and i have that just in using the u thing also no loose bits near the heater relay . Took the new pressure switch off blew down the tube just got bubbles checked the filter clean as a whistle. Now put the old pressure switch back on and tried a hot...

Thanks for that . By the codes that would be no.1 heater relay but why would that make the m/c keep filling with water ?. Also do you know where the heater relay is situated Many thanks Robroy

Hi can anybody help with my indesit washer dryer widl126 It keeps filling with water and i have replaced the pressure switch and now the front panel card but it is still the same and the leds are flashing ,the lock red light is flashing fast and the time delay is flashing every second . regards...