Recent content by Rodreguez

Oh you mean the one where the pcb stops the gas valve going full rate and never gets above 42 degrees due to eec European stuff or something where pcb's are made. British gas software also confirms this is the case !! Besides its fixed now n'all

Oh it was the PCB in anti scald mode BTW :D forget to respond sometimes sorry

oops should have posted in combustion chamber sorry.

gas pressures champion etc. Forgot to mention this is a downstairs flat. An identical system in every way is in the upstairs flat. At the same out let but in the flat upstairs the boiler will read 58 degrees and the hot water is too hot to keep your hand under too long. I services...

Hello been a while. Got a vokera linea just lukewarm hot. Dhw temp on boiler display reads 42 degrees and no more at 10 lites per min. When you close hot tap temp on display reads 58 degrees. Pipes to diverter manifold are very hot. Diverter overhaul kit has been used but no difference. Any...

my fist's have already sorted that problem.

Hi, I require a CCTV security system that will give me good clarity if poss, mainly night time and a bit day use. I have a long garden out the front (30-40 mtrs) and a small back yard where i keep my van on a night. Its a rough neighbourhood, gates get kicked in and usual stuff...

What about the one shot trip ?

Hi, Anyone handy with the older version of the mira advance atl 8.7kw shower ? I have 240v at the terminals on shower and no red led light is on? shower is dead. Mira have advised they cant help me other than get their engineers out at 150ish quid. I know there is a pcb, relay...

Yes I see what you mean but this boiler is old and used to work fine in the past. Or so they have led me to believe. They keep saying it fine when CH is on? Mabey its me listening to them too much and the boiler is fine. Thanks for the help from everyone .

oops should read when incoming cold water becomes cooler

so it isnt true that when set to max temp this boiler will reach 65 degrees or more ? I was thinking after my initial test over 1 minute, the correct temperature rise was acheived, but the temperature will not go up any further even when on max setting after a prolonged period. petit_pablo...

sorry my previous post not too clear. even after 30 mins the hot water would still be 51/52 degrees

incoming cold temp 17 deg ! Temperature rose to no more than 51/52 degrees with a flow rate of more than 12ltr/min. Lady now thinks her hot water is fine. burner pressure is at 12.5, g4 meter gas rate 3.23 I noticed at one point the boiler temp guage read 80deg plus and the pump was...

Because im still learning and didnt write them down. :oops: New I should have kept my mouth shut till later