Thank you.
I will give all this a try when i'm able to get up there. I can see some dirt inside of it, so there must be water getting into somehow.
I will get it open, check all the mounts, we did put the 3 in when we put it on, so I know they are all there.
Could have become loose over time I...
Just to update.
Like clockwork 5 minutes ago the alarm went off again.
I had performed the fix earlier this morning, and the alarm did go off, but after about 2 seconds it stopped itself and went off.
I checked the control panel and no error message or anti tamper red light had come on. and...
Thank you. What I will do is the link (Leave the wires in) and see how it goes over a few days this and next week.
If it goes not go off, then i Know that's the problem. And will then attempt to go up there.
Many thanks everyone. You guys are awesome !
Thank you for the reply.
So I can just link it out on the panel by adding a link between OV & TAMP ?
And remove the two wires also ? Or leave the wires in ?
And that should stop it. And the only issue will be that if I open it up in the future it will set off the entire system ?
But that...
Yes it was a DIY job fitter by my father, who is an electrician.
He asked me if I wanted the tampers on the sensors and I said there was no need for him to wire them up.
But it's worked great for the last 3 years with no problems at all.
So what you are saying is if I bridge the Black Insert...
Hi All,
We had our Alarm installed about 3 years ago.
Just in the last few months, when its a sunny day, around 1pm when the bell box is right in the sun, the entire alarm system goes off.
The Alarm is not set during this time as i'm here inside.
On the Veritas display it just has error code...