Recent content by rosss2000

Thanks Dave, yes i will do that and wire it up to the timer, and leave the old stat in place dormant :) Thanks everyone for your help - much appreciated Ross

Thanks again - no trouble at all Dave, ok it is a Valiant Turbomax plus Combi boiler. The salus stat i have is just a stat, it is not programmable as i did want to keep the honeywell timer. Thanks Ross

Sorry boiler is a Combi boiler made by Valiant. Here is a pic of current timer wiring: http://img195.imageshack.us/img195/605/timerf.jpg Thanks Ross

I think i have worked it out, brown is Timer Live?, and yellow is switched live - if so could i not swap the wire on the timer to the permanent live or does it need both? Sorry to sound clueless, the timer is a honeywell ST6100C Thanks Ross

Ahh it is ok i will get the plumber to do it if to complicated, if i cannot use existing wires from the honeywell stat or swap them around. Can i ask on the old stat it has blue brown and yellow wires, are brown and yellow switched live? Just one of my mates is saying that brown is live and...

The only other thing i can think of doing is remove the current room stat, and then put the new wireless receiver next to the boiler? Would this be a better option, then i can run the live off the boiler direct to the receiver itself? I would prefer to replace the honeywell stat with the new...

Ahh ok got you - thanks. Any way to wire it up then without getting a new wire put in? I presume as per other other thread i could wire it up and leave the timer on "On" all the time, but i would rather not do this so any suggestions would be good? Thanks Ross

Sorry to be pain, but is brown (1) on the honeywell not a permanent live? Just checked on boiler and timer and cannot see how i could run another live as boiler is quite far away. Any help much appreciated :) Thanks again Ross

Thanks, sort of screws me up as cannot get a live to it as is in the kitchen :( Should i send it back and get another model, or will i always need a permanent live regardles of make/model? Thanks Ross

Sorry my fault, that is the receiver for the wireless stat Hope you can help Thanks Ross

Hi there, am trying to make my heating wireless as we have a cold room and need to move the thermostat to this room. I have the Salus RT300RF and am just looking at replacing the honeywell room thermostat and not the timer, i would like to keep this wired in. The wiring differs and i just...