Recent content by runci21

ive layed a screed floor in my bathroom at a depth of 25 mm as per building plans , its bean layed for a month and is cracking badly and i have some doubts if it is sticking to concrete below , concrete is 5 inches thick and was layed 3 months ago . i did not use any sealer on concrete on...

is it possible to control one light from 3 light switches ???

im looking to replace my hot water tank and relocate it , at the moment i have a 65 litre tank in bedroom approx 25 meters from nearest tap i want to move it to bathroom and reduce it size as im removing bath and fitting a large shower cubicle with electric shower . idealy im looking for a tank...

i did my apprenticeship with blue circle and i had to have a basic medical and colour blindness test

i put a mk board up last weekend and i cant fault it , plenty of room and well laid out

whats the cable for on the right hand side with the terminal block

supply across two phases should be 415v not 315v , did you measure 315v ???

where i live there is no mains gas available and i did not have a site for an oil tank . there are a lot off people in the nearby village that have converted from bulk gas to electric wet heating . my dad's electric bill is about £ 45 a month for his total electricity consumption

what type off heating do you have at the moment ?? do you have radiators in place ??

water comes direct from boiler when its called for , sytem is controlled by danfoss tp5000 +rf fully adjustable times and temperture in each time zone . with the rate i have it's off peak 18 hours off the day . i needed to change consumer unit to handle two incoming meter tails , i also feed...

only had meter fitted for two weeks and with this weather ive not had heating on . my hot water comes from the immersion but im going to change that so boiler runs through immersion tank before heading to radiators . ive got a trianco aztec 12 kw system which heats my 3 bedroom semi ( 200 year...

is the cover tight on mcb's ?? do they have room to operate ???

ive got electric wet heating , im on scottish power 2000 economy rate . cheap rate 02.00-08.00,10.00-16.30,18.30-2400.

they used 16mm t+ e cable

im using a hager 63A mcb at the moment thats what the installation engineers fitted into my old clipsal board .