Recent content by Rushi P

So Fly and Madrad, thought I’d provide up update and take the opportunity to say thank you for all the input. The plumber has been and gone and the issue looks to be sorted. He started a power flush and realised that when rotating the flow the opposite way there was an issue. I've put a...

I got the house done back in 2017, didn’t even use the UFH much last winter. Makes sense about the mag filter being close to boiler, the make is a MagnaClean (well that’s all I see on it) have added a picture. The flow meters did have a rusty look about them before I cleaned them out. I’m also...

Thanks, we discussed the mag filter because I did mention that this should pick it up but the plumber said it has been fitted on the return. so I guess it means the particles go through the under floor heating. I’ll check this with the plumber before he starts tomorrow, thanks

So I had a plumber round yesterday, just because I’ve spend way too much time trying to figure this issue out. He feels that although I’ve tried to flush the system out using a home hose, this would not generate enough force to clear out the dirty that may have been caused. He feels the...

Thanks Fly, so you make a great point to which I have done but not mentioned esrlier. I closed all flow meters and left one open. It worked! Hence why I purchased the Salus auto balance actuators. Do you think I should repeat the process for each zone?

Hi Fly, The pump is newly fitted because I thought that was the issue, seems to be running fine. I have set the mix temperature to 50, it was 45 before. The thermostat is constantly calling for heat, I see the boiler temp plus the flow pipe from the boiler is very hot. The flow temperature...

Hi All, I was wondering if someone could help me, I've been struggling so much with one outstanding issue in regards to my underfloor heating. All of the zoned Flow meters/gauges don't seem to be indicting an increasing in flow, I have attached a picture to show you... I have recently taken...

Thank you everyone for the guide. I’ll have to get an engineer to have a look. Just some answers to some of the points. the pump temperature is to 40. I really hope the pipes have not collapsed. I’ve added a picture of it helps, thanks all

Thanks Bernard, sorry I forgot to mention these important points. I'm getting a loft conversion done at the moment, the builder has some knowledge and advised that the pump and valves (are these the actuators) are functioning. For the pump - he unscrewed the bit in the middle to check Valves -...

Hi All, First time I've ever posted on a forum. I was wondering if anyone can help me please. I've had a new heating system installed for a couple of years now but have an issue with our underfloor heating, connected to a Nest thermostat, probably the wrong thermostat to use but this is the...