Hi All,
I was wondering if someone could help me, I've been struggling so much with one outstanding issue in regards to my underfloor heating. All of the zoned Flow meters/gauges don't seem to be indicting an increasing in flow, I have attached a picture to show you...
I have recently taken the flow meters out to clean the dirt inside, just in case something is clogging it up but this has caused what looks to be a little air in the tube... The red indicator continues to stay up.
The actuators are opening the valve, the flow seem to get hot, but the return pipes do not, I've had the heating on solid for 2 days.
All seems okay with the system apart from this annoying issue! Do you think I need to replace them?
Thermostat calling for hot water
45" heat going through pump.
Pump switching on and off
Actuators open valve
I even purchased some Salus Auto Balancing actuators thinking that this will resolve the issue because they have senors on the flow and return pipes to balance the temperature.
In fact I have to say I got a 15 minute spurt whereby the return pipes got piping hot, I though it was all resolved but it didn't last.
I'm sure this all boils down to not having enough flow in pipe system as indicated by the flow meters.
Any suggestions on what I can do?
Any assistance would be much appropriated, this is really giving me a headache just thinking about it constantly for the past few days!
Thanks in advance
I was wondering if someone could help me, I've been struggling so much with one outstanding issue in regards to my underfloor heating. All of the zoned Flow meters/gauges don't seem to be indicting an increasing in flow, I have attached a picture to show you...
I have recently taken the flow meters out to clean the dirt inside, just in case something is clogging it up but this has caused what looks to be a little air in the tube... The red indicator continues to stay up.
The actuators are opening the valve, the flow seem to get hot, but the return pipes do not, I've had the heating on solid for 2 days.
All seems okay with the system apart from this annoying issue! Do you think I need to replace them?
Thermostat calling for hot water
45" heat going through pump.
Pump switching on and off
Actuators open valve
I even purchased some Salus Auto Balancing actuators thinking that this will resolve the issue because they have senors on the flow and return pipes to balance the temperature.
In fact I have to say I got a 15 minute spurt whereby the return pipes got piping hot, I though it was all resolved but it didn't last.
I'm sure this all boils down to not having enough flow in pipe system as indicated by the flow meters.
Any suggestions on what I can do?
Any assistance would be much appropriated, this is really giving me a headache just thinking about it constantly for the past few days!
Thanks in advance